andreychip Posted April 23, 2018 Share Posted April 23, 2018 Hello. How to add 2 axes to the PowerPmacNc16-SDK project, the B-axis (circular) and the W-axis (axis built-in to the spindle), and change the subprog ComputeNCTransform? Link to comment Share on other sites More sharing options...
Omron Forums Support Posted April 27, 2018 Share Posted April 27, 2018 In general we don't transform the rotary axes other than the addition of offsets. I will send you an example project which show how 5-axis were added to a project. Link to comment Share on other sites More sharing options...
andreychip Posted April 28, 2018 Author Share Posted April 28, 2018 In general we don't transform the rotary axes other than the addition of offsets. I will send you an example project which show how 5-axis were added to a project. my username on GitHub AndreyErsted. My mail: Andrey.krasnynsky@gmail.com. Thanks, I'll wait. Andrey. Link to comment Share on other sites More sharing options...
andreychip Posted May 15, 2018 Author Share Posted May 15, 2018 In general we don't transform the rotary axes other than the addition of offsets. I will send you an example project which show how 5-axis were added to a project. Hello! How to get an example ? Best regards. Andrey. Link to comment Share on other sites More sharing options...
zerbzhang Posted April 11, 2019 Share Posted April 11, 2019 Please check the mail, the example project(VISUAL studio ) has been sent, please make sure you have the runtimer nc key, otherwise you can't open it. Link to comment Share on other sites More sharing options...
Recommended Posts