Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
kinematics with NC pro2
#1
I would like to turn tool tip type programming on and off
in a part program. When the NC is launched it sets the motor scaling.
Of course to use kinematics the motors are set to I (#1->I)
Is there a suggested method to switch in and out of kinematic when running
the NC pro2 software?
Reply


Messages In This Thread
kinematics with NC pro2 - kramrellim - 08-16-2016, 11:16 AM
RE: kinematics with NC pro2 - cncguru - 02-08-2017, 06:09 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)