Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Power Pmac Control Servo Position using Analog
#4
In your snip above, select "ControlType" = Torque.
Then you must also select the "Command Signal Channel", "Amplifier Fault Level", and "Primary Feedback Channel" from the dropdown lists.
Reply


Messages In This Thread
RE: Power Pmac Control Servo Position using Analog - StephenJ - 05-26-2015, 09:37 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)