Thread Rating:
  • 0 Vote(s) - 0 Average
  • 1
  • 2
  • 3
  • 4
  • 5
Macro setting problem
#1
Macro setting problem
Hello,

I have total 24 axis,20 axis in Power UMAC rack,and 4 in another rack with Macro 16 CPU connected by ACC-5E3 thought MACRO.
The 24 axis work well normally,but the last 4 aixs(20~24) closed-loop though MACRO(ACC5E3,MACRO 16 CPU,ACC24E2S) was not stable sometimes,the position was changed very big size(about 3000 cts max)because ix11 was set by 0,so the close loop is still work.Of cousrse nobody send any command in this situation.So the machine shake there.When the problem appeared,have to recycle the power supply,and if it was still bad,have to recycle the power again,untile it become well,may need 3 or 4 times.And I'm sure it's not cause by Closed loop oscillation.

I geuss the reason was the parameter about MACRO Clock synchronization was not correct,but I'm not sure.


Thanks a lot!
Reply


Messages In This Thread
Macro setting problem - dzrong - 10-19-2014, 11:50 PM
RE: Macro setting problem - *** - 10-20-2014, 10:28 AM
RE: Macro setting problem - dzrong - 10-20-2014, 04:42 PM
RE: Macro setting problem - dzrong - 10-21-2014, 11:55 PM
RE: Macro setting problem - *** - 10-22-2014, 12:54 PM
RE: Macro setting problem - bradp - 10-23-2014, 01:03 AM
RE: Macro setting problem - dzrong - 10-23-2014, 06:55 AM
RE: Macro setting problem - akirao - 10-24-2014, 03:16 PM
RE: Macro setting problem - dzrong - 11-01-2014, 09:41 PM
RE: Macro setting problem - akirao - 11-03-2014, 10:33 AM
RE: Macro setting problem - steve.milici - 11-03-2014, 05:11 PM
RE: Macro setting problem - dzrong - 11-05-2014, 07:57 AM

Forum Jump:


Users browsing this thread: 1 Guest(s)