Jump to content
OMRON Forums

PE problem


dcwei

Recommended Posts

I want to use "PE " command to watch which line of Motion Program is

running.But i have a problem, if the program have "dwell" or at the end of the program ("ret"),the "PE" command will go wrong.

For example

open prog 1 clear
Linear ;line 0
ABS    ;line 1
TA 500;line 2
TS 250;line 3

x 1000 ;line 4
x -500 ;line 5
x 200  ;line 6
x -1000;line 7
dwell 200 ;line 8
x 1000;line 9
x 0 ;line 10
close

if i run the program,and add "PE" in Watch window,then the line number

will changed from 5 to 8 suddenly.But motion of the moto is normal.

if the Program include P Variable ,“IF……” or “while……” , the line number

will become more strange.

i found that assignment to a P Variable would takes 2 line.

i want to know the reason.

Thanks!

Link to comment
Share on other sites

  • Replies 4
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Hi,

 

What is the "thread delay period" on the watch window?

 

(Right-click in watch window, select lowest number)

 

((You could also prove this by adding Dwells after lines 4,5,6))

 

Mr P Mac.

 

Thanks

 

My watch window thread delay period is 100.

PEWIN32PRO2 said that is the minimum value.

I don't think the problem is the value of thread delay period.

I think the motion program after compiling,the containt has changed.

Link to comment
Share on other sites

Hi,

 

What is the "thread delay period" on the watch window?

 

(Right-click in watch window, select lowest number)

 

((You could also prove this by adding Dwells after lines 4,5,6))

 

Mr P Mac.

 

Thanks

 

My watch window thread delay period is 100.

PEWIN32PRO2 said that is the minimum value.

I don't think the problem is the value of thread delay period.

I think the motion program after compiling,the containt has changed.

 

Hi,

 

try adding dwell0 after each lines 4,5,6, it will act as a delimiter and compile differently.

 

Mr p mac

Link to comment
Share on other sites

Hi,

 

What is the "thread delay period" on the watch window?

 

(Right-click in watch window, select lowest number)

 

((You could also prove this by adding Dwells after lines 4,5,6))

 

Mr P Mac.

 

Thanks

 

My watch window thread delay period is 100.

PEWIN32PRO2 said that is the minimum value.

I don't think the problem is the value of thread delay period.

I think the motion program after compiling,the containt has changed.

 

Hi,

 

try adding dwell0 after each lines 4,5,6, it will act as a delimiter and compile differently.

 

Mr p mac

 

Thanks

i have got the answer.The PE or List PE command only applies for this application that only contains “X 50 ……Y 30……”

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...