kjcho Posted July 24, 2013 Share Posted July 24, 2013 Hi, I want to use EtherCAT Drive support Modular Device Profile. (One Drive, two axes operation...) But as I know, IgH EtherCAT Master Stack doesn't support MDP devices. How about PPMAC?? Does PPMAC EtherCAT Master supports MDP devices?? Link to comment Share on other sites More sharing options...
FWTech Posted July 30, 2013 Share Posted July 30, 2013 Hi, I want to use EtherCAT Drive support Modular Device Profile. (One Drive, two axes operation...) But as I know, IgH EtherCAT Master Stack doesn't support MDP devices. How about PPMAC?? Does PPMAC EtherCAT Master supports MDP devices?? Hi KJCHO, The current Power PMAC IDE (version 1.5.0.21) doesn't support the Modular Device Profile. As I know, the next coming version should support it. FW Link to comment Share on other sites More sharing options...
Omron Forums Support Posted August 5, 2013 Share Posted August 5, 2013 Hi, I want to use EtherCAT Drive support Modular Device Profile. (One Drive, two axes operation...) But as I know, IgH EtherCAT Master Stack doesn't support MDP devices. How about PPMAC?? Does PPMAC EtherCAT Master supports MDP devices?? Hi, Currently PowerPMAC Setup tools does not support MDP . It will be supported in the future . We have not decided the timeline yet but will post as soon as we decide. Thanks, Atul Link to comment Share on other sites More sharing options...
orhirshfeld Posted August 7, 2019 Share Posted August 7, 2019 Is still not supported? I'm using Power Pmac IDE version 4.1.0.24 with PPMAC NY-51 Controller (CPU:X86 Firmware:2.5.0.0) I wish to connect to FESTO CTEU and they provide few different ESI I'm not sure which one I should load, also the ESI Manager doesn't let load all files, I believe because there are two files with the same name. They give two types, one suitable for OMRON Sysmac Studio and other type is for suitable for BECKHOFF TwinCAT readme file of FESTO: Festo CTEU-EtherCAT ESI files Default behaviour of our CTEU-EC is Modular Device Profile (MDP). To change it please take a look on "CTEU-EC Config fix-mdp_EN.pdf" for reprogramming the EEPROM. In this package you find following ESI files for OMROM Sysmac Studio and Beckhoff TwinCAT: OMROM Festo CTEU-EtherCAT Modular - use it if PLC support MDP (work Sysmac Studio > V1.06) Festo CTEU-EtherCAT Fix - can be used after reprogramming the EEPROM on most PLCs TwinCAT Festo CTEU-EtherCAT Modular - use it if PLC support MDP Festo CTEU-EtherCAT Fix - USINT - can be used after reprogramming the EEPROM on all PLCs Festo CTEU-EtherCAT Fix - BYTEARR - can be used after reprogramming the EEPROM on most PLCs Please install only one Fix configuration ESI files at the same time. Link to comment Share on other sites More sharing options...
Recommended Posts