Jump to content
OMRON Forums

Unable to run parametric program


PEERPSI

Recommended Posts

I'm attempting to run a parametric program used on an older A600 system. The program executes to a certain block and then just stops. The number of lines versus lines in the program starts to increase rapidly and the program window shows no text with just a yellow bar.

 

I've stripped out the parts that the program should run based on what the parameters are and when I just run that part in a seperate program it runs fine.

 

Any ideas?

Link to comment
Share on other sites

  • 2 weeks later...
  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Solved this tonight. My var.dat file had a number of undefined entries represented by #0. I went through the list of vars, 500-599, that we use in the program and set those without values or those that represent a logical 1 versus 0 to defined 0 values. This means that their entries in the var.dat file are now represented by a 0 instead of a #0.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...