Jump to content
OMRON Forums

Using ACC-72E with servo drive


dzrong

Recommended Posts

  • Replies 6
  • Created
  • Last Reply

Top Posters In This Topic

Thanks for you reply.That what I want exactly.

So you pmac works in the close loop mode,I mean you get the feedback data from profibus.

How many axis you control throw the profibus?

2ms was too slow for close loop control I think,can I control that using open loop way?I mean only send position command to servo drive throw profibus,the only question worried me was the precision of the position command,24bits? or higher?

Link to comment
Share on other sites

  • 1 year later...
  • 5 years later...

Thanks for you reply.That what I want exactly.

So you pmac works in the close loop mode,I mean you get the feedback data from profibus.

How many axis you control throw the profibus?

2ms was too slow for close loop control I think,can I control that using open loop way?I mean only send position command to servo drive throw profibus,the only question worried me was the precision of the position command,24bits? or higher?

 

hello, how are you use 72e control drive with open loop way ?

Link to comment
Share on other sites

  • 3 weeks later...
Guest
This topic is now closed to further replies.

×
×
  • Create New...