Jump to content
OMRON Forums

J+ or J- from CPLC


Amir

Recommended Posts

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

You can always use the GetResponse() or the Command() functions to send anything you would normally send from the IDE terminal. Make sure you only do these in a one-shot fashion or based on some reasonable time delay (at least on servo cycle) so that you do not overwhelm the PPmac command parser.
Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...