Jump to content
OMRON Forums

IDE 4.2.1.19 for power clipper


ulhasfegade

Recommended Posts

  • Replies 1
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

IDE version is not specific to form factor. For Firmware 4.2.1.19, you may want to make sure you are using relatively recent firmware. For EtherCAT, IDE 4 can only handle Acontis. If you are using Etherlab EtherCAT you will also need IDE 3.

 

There is an IDE/Firmware compatibility chart in the IDE manual. This is available under "Help -> "PowerPMAC IDE Manual" within the IDE. The chart should be on page 10.

Link to comment
Share on other sites

Guest
This topic is now closed to further replies.

×
×
  • Create New...