fiedel Posted June 28, 2019 Share Posted June 28, 2019 I connected a Renishaw 26-bit BiSS-C encoder to the PMAC and I'm monitoring the two encoder signals with a oscope. In PEWIN the Cts Per Unit is set to 1, and the position shows 107500. On the oscope it shows 631787 (26-bit position only, status and CRC bits removed). The waveform format is exactly as defined in the BiSS-C protocol, and CRC is correct, so I assume there's no error/noise causing measuring problem. Then how could the two readings be so different? Is the position window in PEWIN showing the raw read back value from the encoder? Link to comment Share on other sites More sharing options...
steve.milici Posted July 3, 2019 Share Posted July 3, 2019 This would be a technical support issue. Please contact ODT's technical support at: ODT-Support@omron.com Link to comment Share on other sites More sharing options...
Recommended Posts