Jump to content
OMRON Forums

How to clear Sys.AbortAll?


maxvoxel8

Recommended Posts

In the manual it says:

 

The Sys.AbortAll status bit is set to 1 when Power PMAC is stopping or has stopped due to the “Abort All” input, even if the input is no longer set in the abort state.

Sys.AbortAll is set back to 0 when the input is not set and any motor or coordinate system is commanded to exit its final “abort all” state

 

What commands cause exiting the final abort all state?

 

We have been using &1enable for this, but we now can't do so anymore because the drives can only be engaged under certain conditions. As a workaround I tried defining a second coordinate system assigned to an unused motor, and enabling that also clears the flag. But I don't like this approach because we may need that motor in C.S. 1 at some point. Is there a better way to do this?

Link to comment
Share on other sites

  • Replies 4
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Guest
This topic is now closed to further replies.

×
×
  • Create New...