Jump to content
OMRON Forums

PMAC-PC(1) Open loop spindle


Eyewonder

Recommended Posts

I'm looking for an app note, or example of implementing open loop control of spindle for a bench-top wood router. The 4th axis is available for that use. The spindle is rated for ~20,000 RPM, but has no encoder, or tach. I believe the spindle drive gets low voltage (0-10?) for speed command from a pot on its drive cabinet.

 

I would like to be able to issue an 'S1500' etc cmd for speed, and an M03/M04/M05 to turn it on & off.

 

The card is PMAC Universal Lite w/DPR on board, using PMAC-NC32 v2.36(1), WinXP SP3.

 

Cheers,

Steve

Link to comment
Share on other sites

  • Replies 0
  • Created
  • Last Reply

Top Posters In This Topic

Popular Days

Top Posters In This Topic

Guest
This topic is now closed to further replies.

×
×
  • Create New...