hannsx Posted March 28, 2018 Share Posted March 28, 2018 Hi, I want to share my problems and solution for other people to benefit of it. The File ist not available on the File depot, so you have to specifically ask the support for the newest File. In my case I got the Files from my supervisor and that did not work. Problem: I was not able to connect to the MotionCore.VBox Machine with my PMac IDE. Solution: Use the newest MotionCore.Zip file. The File ist not available on the File depot, so you have to specifically ask the support for the newest File. In my case I got the Files from my supervisor to start with and that did not work. Link to comment Share on other sites More sharing options...
orhirshfeld Posted May 2, 2019 Share Posted May 2, 2019 I encountered a similar issue and I got an error from IDE also, I succeed to connect with ssh but when I try to run "gpascii" or "sendgetsends" i get the following error: rtpmac open, Err Msg: (No such device or address) Segmentation fault I attached photos to this post to demonstrate to errors I got I wonder if you encountered a similar issue to what I described in this post? also I saw that there are two versions of MotionCore.zip files on the fieldepot: MotionCore.zip old version: ftp://ftp.deltatau.ch/Virtual-PowerPMAC-pack/OLD/MotionCore.zip MotionCore.zip latest version ftp://ftp.deltatau.ch/Virtual-PowerPMAC-pack/MotionCore.zip I tried both and failed, did you tried both? Host OS : Ubuntu 16.04 VM SW: VirtualBox 6.0.6 IDE 4.1.0.24 running on Virtual Machine of Win10 Thank you, Or Hirshfeld SW Control Engineer FFRobotics https://www.linkedin.com/in/orhirshfeld/ Link to comment Share on other sites More sharing options...
maccadt Posted May 2, 2019 Share Posted May 2, 2019 Hi hannnsx and orhirshfeld probably your license for the virtual MotionCore is expired. You have to ask for a new one sending a request to: fmacaluso@deltatau.ch Hi, I want to share my problems and solution for other people to benefit of it. The File ist not available on the File depot, so you have to specifically ask the support for the newest File. In my case I got the Files from my supervisor and that did not work. Problem: I was not able to connect to the MotionCore.VBox Machine with my PMac IDE. Solution: Use the newest MotionCore.Zip file. The File ist not available on the File depot, so you have to specifically ask the support for the newest File. In my case I got the Files from my supervisor to start with and that did not work. Link to comment Share on other sites More sharing options...
Recommended Posts