Jump to content
OMRON Forums

reset failed - new strange behaviour!


steveneads

Recommended Posts

I've had a few occasions recently where PowerPMAC has been behaving very oddly after downloading code and it's been apparent that code is not running correctly. My remedy has been to do a "clean" and re-download and save the code, and then to issue a $$$. On several occasions the reset has not happened and eventually the message "PowerPMAC reset failed" appears.

 

What is happening?

 

The only remedy then seems to be to repower the system - and then things seem to work normally again.

 

Any ideas?

Link to comment
Share on other sites

  • Replies 3
  • Created
  • Last Reply

Top Posters In This Topic

Top Posters In This Topic

Guest
This topic is now closed to further replies.

×
×
  • Create New...