PEERPSI Posted February 18, 2013 Share Posted February 18, 2013 According to the manual certain G-codes are supposed to be default startup. I'm finding that is not the case for instance I need to command G63 Radius mode as it defaults to diameter. I'd also like to set G01 as the default rather then G00. What is the recommended method of setting default G-codes and what could be the reason mine is not going to what the manual states. Any ideas? Link to comment Share on other sites More sharing options...
PEERPSI Posted February 20, 2013 Author Share Posted February 20, 2013 Found the settings in the registry for correcting this. Under the section Code I needed to change the Default and SetOnReset values to the code I wanted to be set on startup. Link to comment Share on other sites More sharing options...
Recommended Posts