Delta Tau Forums
IDE will not connect but SSH will - Printable Version

+- Delta Tau Forums (http://forums.deltatau.com)
+-- Forum: Delta Tau Data Systems (http://forums.deltatau.com/forumdisplay.php?fid=1)
+--- Forum: Power PMAC (http://forums.deltatau.com/forumdisplay.php?fid=2)
+--- Thread: IDE will not connect but SSH will (/showthread.php?tid=3259)



IDE will not connect but SSH will - eriochrome - 08-04-2021

I am having a communication problem with my PowerBrick. After building and downloading a new project and saving it something crashed. The IDE stopped being able to communicate with the PowerBrick. I tried the USB Factory reset and have found that the PowerBrick can be SSH to but will not respond to IDE.


RE: IDE will not connect but SSH will - eriochrome - 08-05-2021

Factory Reset USB does not help. I tried the no RT usb and get a different response when I try to run gpascii from the SSH window. With RT I get no response in the SSH window but a flashing cursor on a new line, with NoRT I get a "no such device or address".


RE: IDE will not connect but SSH will - eriochrome - 08-05-2021

Seems that the Project I loaded messed up the Powerbrick and I somehow was saving it just as it was dying and the whole usrflash folder was gone on the Powerbrick file system. I loaded a USB with a known good project and placed the files in the usb PowerPmacConfigLoad/usrflash/Project.
This recovered communication in the IDE. Once I had communication I tried to reload from one of the flash.n files but that failed also so I am just repeating the basic changes to the project one at a time to source the issue.


RE: IDE will not connect but SSH will - steve.milici - 08-06-2021

Capture the boot response for diagnostics. Contact ODT Technical Support with the results to review:
ODT-Support@Omron.com