Delta Tau Forums
J+ or J- from CPLC - Printable Version

+- Delta Tau Forums (http://forums.deltatau.com)
+-- Forum: Delta Tau Data Systems (http://forums.deltatau.com/forumdisplay.php?fid=1)
+--- Forum: Power PMAC (http://forums.deltatau.com/forumdisplay.php?fid=2)
+--- Thread: J+ or J- from CPLC (/showthread.php?tid=324)



J+ or J- from CPLC - Amir - 12-02-2010

Is there a way to do a J+ or J- in a CPlc? All I found was the JogPosition() function which is the equivalent of J=.


RE: J+ or J- from CPLC - bradp - 12-02-2010

You can always use the GetResponse() or the Command() functions to send anything you would normally send from the IDE terminal.

Make sure you only do these in a one-shot fashion or based on some reasonable time delay (at least on servo cycle) so that you do not overwhelm the PPmac command parser.