Delta Tau Forums
PowerPMAC Clipper APM86xx freezes - Printable Version

+- Delta Tau Forums (http://forums.deltatau.com)
+-- Forum: Delta Tau Data Systems (http://forums.deltatau.com/forumdisplay.php?fid=1)
+--- Forum: Power PMAC (http://forums.deltatau.com/forumdisplay.php?fid=2)
+--- Thread: PowerPMAC Clipper APM86xx freezes (/showthread.php?tid=3083)



PowerPMAC Clipper APM86xx freezes - andreychip - 05-22-2020

Hello!
I have a problem with the controller Clipper APM86xx freezing.
I am using Power PMAC-NC 8 axes. In manual mode, everything works well.
In Auto and MDI mode, when starting on the G0X100Z-100 frame, the controller starts moving and freezes (stops working).
It starts to work after a full reboot.
What could be?

–°ontroller configuration 8 axis .
ACC-8FS -2 boards
ACC-24S3-1 board
Thanks in advance for your help.


RE: PowerPMAC Clipper APM86xx freezes - andreychip - 05-25-2020

Hello!
I figured out the problem. The problem is firmware 2.4.0.180.
When I replaced the controller with a new one, everything worked with firmware 2.5.0.4 . I updated PowerPMA–° to version 2.5.0.4 and it worked.
I upgraded PowerPMAK to version 2.5.0.4 and it worked. Where can I get the latest update for CPU 465(Clipper)?
Thank you!
Andrey.


RE: PowerPMAC Clipper APM86xx freezes - steve.milici - 05-27-2020

This would be a technical support issue.
Please contact ODT's technical support at:
ODT-Support@omron.com