Delta Tau Forums
ACC-72E Profibus Master-Global bit - Printable Version

+- Delta Tau Forums (http://forums.deltatau.com)
+-- Forum: Delta Tau Data Systems (http://forums.deltatau.com/forumdisplay.php?fid=1)
+--- Forum: Turbo PMAC (http://forums.deltatau.com/forumdisplay.php?fid=6)
+--- Thread: ACC-72E Profibus Master-Global bit (/showthread.php?tid=3008)



ACC-72E Profibus Master-Global bit - guoke1225 - 12-02-2019

I use a ACC-72E PROFIBUS MASTER Card in my Project, and I set the SW in below configuration
SW1-ON,SW2-OFF,SW3-ON,SW4- ON,SW-5-ON,Sw-6-ON,
so the address DPR base address is $74000, I wants to monitor the diagnostic flags in PLC, I calculate the address for the Global_bits, DPM_state, Err_rem_adr according their offset address , their offset address is respectively 740H, 741H,742H described in manual.
Global_bits; M6800->Y:$74740,16,8,U
DPM_state: M6801->Y:$74741,16,8,U
Err_rem_adr: M6802->Y:$74742,16,8,U

the Value of Global_bits which is in Sycon is not equivalent with the value which is in UMAC.
What's the matter´╝č the address calculation is wrong ?