Delta Tau Forums
GateIO address detection - Printable Version

+- Delta Tau Forums (http://forums.deltatau.com)
+-- Forum: Delta Tau Data Systems (http://forums.deltatau.com/forumdisplay.php?fid=1)
+--- Forum: Power PMAC (http://forums.deltatau.com/forumdisplay.php?fid=2)
+--- Thread: GateIO address detection (/showthread.php?tid=22)



GateIO address detection - DT-Europe - 09-11-2008

The IO Gate addresses detected don't reflect the dip switch setting done on the different IO boards, but the memory map to access th IO is correct.


e.g.
setting of our dip switches
ACC66E first | $B00000 | Gate IO 4 |
ACC66E second | $B08000 | Gate IO 5 |

The 1st ACC66E is responding on $B00000 but is detected in the sys.CardIOAutoDetect in a wrong bit and the intellisense GateIO[1] instead of GateIO[4].


RE: GateIO address detection - bradp - 09-16-2008

DT-Europe Wrote:The IO Gate addresses detected don't reflect the dip switch setting done on the different IO boards, but the memory map to access th IO is correct.


e.g.
setting of our dip switches
ACC66E first | $B00000 | Gate IO 4 |
ACC66E second | $B08000 | Gate IO 5 |

The 1st ACC66E is responding on $B00000 but is detected in the sys.CardIOAutoDetect in a wrong bit and the intellisense GateIO[1] instead of GateIO[4].


The attached document contains the proper indexes.


RE: GateIO address detection - dgore - 06-03-2009

(09-16-2008, 08:27 AM)brad Wrote: The attached document contains the proper indexes.

Just being stupid: This document is for all I/O boards? (I'm using the ACC-24E2A)