Delta Tau Forums
GEO MACRO GMH051 WITH TURBO PMAC IN PLACE OF BALDOR MACRO DRIVE - Printable Version

+- Delta Tau Forums (http://forums.deltatau.com)
+-- Forum: Delta Tau Data Systems (http://forums.deltatau.com/forumdisplay.php?fid=1)
+--- Forum: FAQ (http://forums.deltatau.com/forumdisplay.php?fid=5)
+--- Thread: GEO MACRO GMH051 WITH TURBO PMAC IN PLACE OF BALDOR MACRO DRIVE (/showthread.php?tid=1395)



GEO MACRO GMH051 WITH TURBO PMAC IN PLACE OF BALDOR MACRO DRIVE - rajkumarattri - 11-08-2013

Dear Sir

in my old cnc's i am using baldor macro drives and i want to replace those drives with GEO GMH152/051 drives, so please post any write up, for geo macro setup with turbo pmac 2 through pewin32 pro.

as currently i am in doubt what pwn frequencies i have to set as shown in manual.

when i make setup through "geo macro drive manual", i am getting fictious noise in velocity whether motor is in open loop.

so please help.

regards
rajkumar attri


RE: GEO MACRO GMH051 WITH TURBO PMAC IN PLACE OF BALDOR MACRO DRIVE - steve.milici - 11-08-2013

Check the current loop tuning of the motor/drive. If this is not well tuned it can cause digital noise. Also verify that you have good PID loop tuning.