Delta Tau Forums

Full Version: ACC-24E2S encoder counter register
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
I used ACC-24E2S and set I7mn0 =8 to make it run in open loop, but the encoder still connected to board, so is it possible to get encoder counter to verify its position, if it is ok, which register can be read? for example ,Servo IC 2, channel 1, I try to read the value which point toM101-> X:$078201,0,24,S,it's failure.
No that is not possible with I7mn0 = 8. If I7mn0 is set to 8, the decoder inputs the pulse and direction signal generated by Channel n's pulse frequency modulator (PFM) output circuitry. An external encoder cannot be used in this setting.