Delta Tau Forums

Full Version: Unsolicited messages: Pb of reconnect
You're currently viewing a stripped down version of our content. View the full version with proper formatting.
When, after a link break, i try reconnect for "unsolicited" :
the .StartUnsolicitedEvent() make an exception with the message : "Error: The following SendFiles are locked and being used, 0, 1, 2, 3, 4"

I use PPcomLib v1.0.0.1 (PowerPmacComLib.dll dated 29/06/2012)
PPmac firmware 1.5.8.0

In my application (or with demo "PowerPmacComLibVBDemoApp") :
- All ways to communicate with PPmac (including Unsolicited) work ok
- When i disconnect the Ethernet link,
- Problems of connections are normaly detected and i close all communications
- I connect again the ethernet link
- I launch all the re-connections,
- All is ok execept for "unsollicited" where an exception occurs on .StartUnsolicitedEvent()
with the message : "Error: The following SendFiles are locked and being used, 0, 1, 2, 3, 4"

Same test can be done simply with the IDE and a unsolicited box opened :
- Disconnect the Ethernet link,
- Restore the Ethernet and reconnect the IDE
- In the Unsolicited box, the red message is displayed :
"Unable to connect to SSH's Unsolicited thread with error Error: The following SendFiles are locked and being used, 1, 2, 3, 4"

- The only way that i found to restore, is to send to PPmac a "$$$"
(11-30-2012, 11:20 AM)sbrun Wrote: [ -> ]When, after a link break, i try reconnect for "unsolicited" :
the .StartUnsolicitedEvent() make an exception with the message : "Error: The following SendFiles are locked and being used, 0, 1, 2, 3, 4"

I use PPcomLib v1.0.0.1 (PowerPmacComLib.dll dated 29/06/2012)
PPmac firmware 1.5.8.0

In my application (or with demo "PowerPmacComLibVBDemoApp") :
- All ways to communicate with PPmac (including Unsolicited) work ok
- When i disconnect the Ethernet link,
- Problems of connections are normaly detected and i close all communications
- I connect again the ethernet link
- I launch all the re-connections,
- All is ok execept for "unsollicited" where an exception occurs on .StartUnsolicitedEvent()
with the message : "Error: The following SendFiles are locked and being used, 0, 1, 2, 3, 4"

Same test can be done simply with the IDE and a unsolicited box opened :
- Disconnect the Ethernet link,
- Restore the Ethernet and reconnect the IDE
- In the Unsolicited box, the red message is displayed :
"Unable to connect to SSH's Unsolicited thread with error Error: The following SendFiles are locked and being used, 1, 2, 3, 4"

- The only way that i found to restore, is to send to PPmac a "$$$"

We are checking the issue and update the forum!
Atul